ASA failover question

Unanswered Question
Apr 2nd, 2009

I have read all the docs regarding ASA failover using the sla monitor command. The doc indicates that the failover occurs between two interfaces (eth0/0 and eth0/1). so my question is that if i have one copper hand off and that goes into eth0/0 and have two vlans on that interface. can i have the same failover using the vlan with sla monitor? or does that just work with physical interfaces?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Anonymous (not verified) Thu, 04/09/2009 - 12:22

Both active and standby ASA's should have the same configuration which applies to VLAN also.


This Discussion