CER Switch Inventory via SNMP

Aaron Dhiman · ‎04-02-2009

CER is unable to get switch port inventory from Foundry Switches. The customer has Foundry Edge Switches.

I am getting the following errors on the CER Server:

2699: Apr 02 14:37:01.409 EST %CER-CER_PHONETRACKINGENGINE-7-DEBUG:CER Message Receiver T:CoreSortSeedDevices getSeedSwitchListFro ip address of host 10.100.0.67 10.100.0.67

2700: Apr 02 14:37:01.410 EST %CER-CER_PHONETRACKINGENGINE-6-INFO: CER Message Receiver T:SMFFactoryLoader getFactoryForId Unable to map oid .1.3.6.1.4.1.1991.1.3.45.2.2.1.1

2701: Apr 02 14:37:01.410 EST %CER-CER_PHONETRACKINGENGINE-7-DEBUG:CER Message Receiver T:CoreSortSeedDevices isSuccefullyAddedInD This device is not supported 10.100.0.67

2702: Apr 02 14:37:01.411 EST %CER-CER_PHONETRACKINGENGINE-7-DEBUG:CER Message Receiver T:CoreSortSeedDevices getSeedSwitchListFro ip address of host 10.100.0.62 10.100.0.62

2703: Apr 02 14:37:01.412 EST %CER-CER_PHONETRACKINGENGINE-6-INFO: CER Message Receiver T:SMFFactoryLoader getFactoryForId Unable to map oid .1.3.6.1.4.1.1991.1.3.45.1.1.1.1

Is there some way to get the Foundry switch ports to show up for ERL Assignments?

Thx.

htluo · ‎04-03-2009

Not surprisingly, CER was designed to work with Cisco switches.

This is because Cisco switches use CDP protocol to collect phone information.

For non-Cisco switches, you have to manually put the phone in ERL, either by subnet or by DN.

HTH

Michael

http://htluo.blogspot.com