AutoQOS with non Cisco VOIP solution

Unanswered Question
Apr 4th, 2009
User Badges:

Hi All,

Can I deploy AutoQOS on my LAN switching and layer 3 switching when using a Siemens VOIP solution. I realise that their phones do not do CDP, so I need to trust the COS on the access port. But can I use all the other AutoQOS settings?


Thanks in advance for your feedback.


Scotty

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Sat, 04/04/2009 - 05:37
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

thierically should be fine if you trust dscp or cos on the access ports and dscp on the uplinks trunks


but make sure from the marking is it cos 5 for voice for example and cos 3 signaling

if not u need to change you qos accordingly


try to capture you trafic with wireshark for example and see the marking


good luck


HTH

scottyd Sun, 04/05/2009 - 00:35
User Badges:

Thanks for the reply.


So what do I do if I want to add other QOS classificatios, like I want to set Citrix traffic into the interactive class. Do I just have to mark the traffic and that is all?


Cheers

Scotty

Marwan ALshawi Sun, 04/05/2009 - 03:55
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

ok marking will be ok to mark the traffic but what after marking ?

you need to think do you need to have policies to prioritize some traffic over other

this way you can use the marked traffic and give to each class bandwidth acorrdengly


HTH

Actions

This Discussion