04-04-2009 10:33 PM - edited 03-06-2019 04:59 AM
I just recently picked up a Catalyst 2948G and would like to find out the following: 1/ how to reset the unit, and 2/ find out if it is possible to manage the unit through CISCO's Network assistant as i am unfamikiar with the CISCO terminal access. I would truly appreciate some assistance regarding this matter.
04-05-2009 12:29 AM
to reset your switch
to check if it is supported by NA see if it is here:
but you need at leat to give it one IP ADDRESS And snmp community string
04-05-2009 09:08 AM
CNA only supports IOS switches that is an older catos box. The only way to reset it is thru command line . The "clear config all" command will reset it. If you get the right catos version on it , it can support a gui interface.The image version would have to a "cv" somewhere in the image name which stands for ciscoview.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide