04-05-2009 08:54 PM - edited 03-06-2019 05:00 AM
Hi,
I have a 6500 box with MSFC3/PFC3 and have upgraded the IOS version to s72033-advipservicesk9_wan-mz.122-18.SXF11.bin. It was running IOS verison before this : s72033-pk9sv-mz.122-17d.SXB11.bin
It does note seem to accept the service-policy output command after the upgrade.
routerA(config)#int gi2/47
routerA(config-if)#service-policy output A-Voice
bandwidth percent command is not supported in output direction for this interface
Configuration failed on: GigabitEthernet2/47
routerA(config-if)#service-policy output A-Voice-100M
bandwidth command is not supported in output direction for this interface
Configuration failed on: GigabitEthernet2/47
Is MQC with the bandwidth or bandwidth percent command not supported on the 6500 series box ?
Pls advice,
Cheers,
- InternetB -
Solved! Go to Solution.
04-06-2009 06:13 AM
Is MQC with the bandwidth or bandwidth percent command not supported on the 6500 series box ?
It's not supported when using regular line cards along with the PFC QoS.
If you purchase a SIP/SPA module, then you can use your regular MQC commands.
Please refer to the documentation:
HTH,
__
Edison.
04-06-2009 06:13 AM
Is MQC with the bandwidth or bandwidth percent command not supported on the 6500 series box ?
It's not supported when using regular line cards along with the PFC QoS.
If you purchase a SIP/SPA module, then you can use your regular MQC commands.
Please refer to the documentation:
HTH,
__
Edison.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: