Checking RADIUS status

Unanswered Question
Apr 6th, 2009

Hi All,

I am doing an upgrade of RADIUS server, I would like if there is any way in which I can check out the RADIUS server is working fine in all autonomous AP and WLC. I want to do it proactively before any customer comes and complaints of the authentication failures..

Any help in the regard is appreciated



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Johannes Luther Tue, 04/07/2009 - 01:04


on IOS APs, there is a test command.

(test aaa ...).

I'm not aware of a test command on the WLC software. But I guess you are not changing the IP, port or shared secret of the RADIUS server, right? You should be good with the IOS test commands.

nikhilcherian Tue, 04/07/2009 - 18:26


Can you guide me how to use the command. I would like to know the following things

Can I specify a RADIUS group ( I have got multiple RADIUS groups configured in my AP)

I see something called legacy and new-code in the last of the command, I couldn't get any help on those things

I tried with 1200 AP withVersion 12.3(7)JA2.



Leo Laohoo Tue, 04/07/2009 - 19:00


If you are using Autonmous IOS, then yes. You can configure RADIUS to your AP like you always do with other appliance.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode