Checking RADIUS status

nikhilcherian · ‎04-06-2009

Hi All,

I am doing an upgrade of RADIUS server, I would like if there is any way in which I can check out the RADIUS server is working fine in all autonomous AP and WLC. I want to do it proactively before any customer comes and complaints of the authentication failures..

Any help in the regard is appreciated

Thanks

Raj

Johannes Luther · ‎04-07-2009

Hi,

on IOS APs, there is a test command.

(test aaa ...).

I'm not aware of a test command on the WLC software. But I guess you are not changing the IP, port or shared secret of the RADIUS server, right? You should be good with the IOS test commands.

nikhilcherian · ‎04-07-2009

Luther

Can you guide me how to use the command. I would like to know the following things

Can I specify a RADIUS group ( I have got multiple RADIUS groups configured in my AP)

I see something called legacy and new-code in the last of the command, I couldn't get any help on those things

I tried with 1200 AP withVersion 12.3(7)JA2.

Thanks

NikhiL

Leo Laohoo · ‎04-07-2009

Nik,

If you are using Autonmous IOS, then yes. You can configure RADIUS to your AP like you always do with other appliance.

Johannes Luther · ‎04-07-2009

Hi,

I don't have an IOS AP available right now. But this should help you out:

http://tools.cisco.com/Support/CLILookup/cltSearchAction.do

nikhilcherian · ‎04-08-2009

Luther,

Thanks for the reply

Cheers

NIK