Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
213
Views
0
Helpful
1
Replies

CCM 6.1.3 Cluster configuration

carlosg
Level 1
Level 1

‎04-07-2009 04:46 PM - edited ‎03-15-2019 05:21 PM

Hi, I tried to configure a cluster in a CCM version 6.1.3 using wizard option, it ask for the publisher name, Ip address and the the security password but it does not work, at the end of the procedure an error was displayed, is there an other way to do that ?

Labels:
0 Helpful
1 Reply 1

gogasca
Level 10
Level 10

‎04-07-2009 09:53 PM

make sure u already added the subscriber under ccmadmin, try using ip addresses.

reset security password in publisher (look procedure in forum or cco)

then re-try adding sub

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents