04-07-2009 11:32 PM - edited 03-06-2019 05:03 AM
Hi~
Chassis is composed of below module.
Chassis = C4510R
Slot1. WS-X4516
Slot2. WS-X4516
Slot3. WS-X4148-RJ-45
Slot4. WS-X4148-RJ-45
Slot5. WS-X4148-RJ-45
Slot6. WS-X4148-RJ-45
Slot7. WS-X4148-RJ-45
Slot8. WS-X4148-RJ-45
Slot9. WS-X4148-RJ-45
Slot10.WS-X4148-RJ-45
When above case run, status of slot10 is "Not Support".
Command is used "show module"
I am wondering why slot10 isnot support.
I think that because Backplan but I don't know well.
04-08-2009 12:07 AM
Hello Kwangwon,
it can be a question of power budget.
What happens if you remove one of the linecards for example the one in slot 3 ?
Hope to help
Giuseppe
04-08-2009 11:57 PM
Hi~ Giuseppe
C4510R' capacity is 136Gbps and WS-X4516' swiching capacity is 96Gbps.
So isn't it possible ?
When I tested linecards it is good.
04-09-2009 12:24 AM
Hello Kwangwon,
I was meaning power consumption of modules not bandwidth or backplane issues
check with sh power
Hope to help
Giuseppe Larosa
04-09-2009 02:22 AM
Hi
The 4516 has 96 1Gig Channel to support the line cards. 6 Are used per slot. Both 4516 borrow theirs uplinks from these 96 Channels. So the slot 10 can a maximum of 2 gig use. So only the 4502 line card can be used in this situation.
The 4516-10GE is different it has 96 Channels for the line cards plus the 10gig uplinks. But you have decide between the 4 1gig ports on the 4516-10GE sup exclusive or the slot 10.
hth
Andy
04-09-2009 02:43 AM
Hello Kwangwon,
The following note can you find at the âRelease Note for the Catalyst 4500 Series Switchâ see the link below:
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/release/note/OL_5184.html
Contains:
When you use Supervisor Engine V in a Catalyst 4510R or 4510R-E chassis, slot 10 (FlexSlot) only supports the following linecards: the two-port GBIC (WS-X4302-GB) and the Access Gateway Module (WS-X4604-GWY). Supervisor Engine V-10GE has this same restriction when you configure its uplink select mode to all. Supervisor Engine V-10GE supports all Catalyst 4500 Series linecards in slot 10 when its uplink select mode is configured as tengigabitethernet or gigabitethernet. Supervisor Engine 6-E supports all Catalyst 4500 series linecards in slot 10.
Andy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide