I have 4500-E serial Catalyst Switch and AP1252AG access point.
WS-X4248-RJ45V (48 Port PoE Card) is installed in 4500-E switch and access point is connected with this switch without power injector. But i am getting LOW power error in AP. AP have 3 radios (2.4 GHz). I have tested with 1 radio also but still i have same problem.
Can you please guide me to solve this problem ?
What power command i have to apply on switch port and AP interface.
Its very urgent please...
From Steve @ Cisco;
Information on the 4500 supporting the 1252 is below:
4500 modules req switch to run 12.2(44)SG or later
power inline port maximum 20000
power inline auto max
From this excellent thread;
Hope this helps!