cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
637
Views
0
Helpful
2
Replies

Input error on trunk interface.

I've seen approximately 90.000 input errors on a gigabit ethernet trunk port of a 4510 chassis. Configuration is as follows;

!

interface GigabitEthernet3/1

switchport trunk encapsulation dot1q

switchport trunk native vlan 3

switchport mode trunk

!

The other end of the loop was on a 3750, with a configuration like;

!

interface GigabitEthernet1/0/24

switchport trunk encapsulation dot1q

switchport trunk native vlan 3

!

After configuring dynamic desirable interface to mode trunk, input errors stopped increasing.

What can be a logical explanation to this situation guys, we are not getting crc's, only input errors, is this normal?

Thanx in advance.

Baha

2 Replies 2

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Baha,

if the side with dynamic desirable puts itself in access mode all frames with a vlan tag different then the access vlan should be discarded.

the behaviour can be dynamic and depends from the fact that the other side can be willing to negotiate or not.

Another possibility is that DTP exchanges information about VTP domain if VTP domain changes a dynamic desirable port will not become trunk.

Hope to help

Giuseppe

BTW here below are the average RX/TX rates on the indicated days.

GigabitEthernet3/1 - Gi3/1

Avrg RX Avrg TX

07-Apr-09 12 Mbps 78 Mbps

06-Apr-09 4,42 Mbps 78 Mbps

08-Apr-09 5,08 Mbps 81 Mbps

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: