One side ATM one side MPLS based Point to Point G.Shdsl Modem Conf.

Unanswered Question
Apr 9th, 2009


I am concerning about what should be done differently or additionaly when forming a topology where cisco dsl routers are used in one side connected to an ATM network and in the other to MPLS network.

Thank you.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Giuseppe Larosa Thu, 04/09/2009 - 02:26

Hello Fatih,

without more details it is difficult to say something meaningful:

you may need ipsec tunnels or not and so on.

Describe your scenario with more details to get better help

Hope to help


Ff1292309 Thu, 04/09/2009 - 04:02

In fact i don't mention a topology which is used for some reasons,ipsec tunnels v.s. but only communicating (with a ping test) these two locations basically. That is, i am concerning about to do ping test from the LAN side of ADSL router connected to the ISP's ATM/MPLS backbone to the WAN interface of the other Router connected to ATM/MPLS backbone.

So what should be done differently at the dsl routers side working two sidesat ATM network, one side ATM the other MPLS or both at MPLS.


This Discussion