04-09-2009 01:49 AM
Hello everybody!
I'm finding an IOS to configure MPLS/Traffic Eng feature on a catalyst 6509 (I have a 6509-NEB-A with sup720/MSFC3 - PFC3A).
Using feature navigator I've check that the train 12.2(33)SXI Adv-IP-Serv or Adv Ent-Serv should support these feature (mpls, ldp, traffic engeneering...).
I've installed It but...I can't configure any feature about mpls!
Any uggestion?
Many thanks in advance for your support
04-09-2009 05:03 AM
Hello Gianluca,
check the type of supervisor you have
sup 720 3B or better is required for MPLS on a C6500 chassis
see on one of our devices
sh module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 24 CEF720 24 port 1000mb SFP WS-X6724-SFP SAD085003LD
2 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX SAL09018DKD
5 2 Supervisor Engine 720 (Active) WS-SUP720-3B SAD085201PZ
sh mpls forw | exclude ntagged
Local Outgoing Prefix Bytes tag Outgoing Next Hop
tag tag or VC or Tunnel Id switched interface
16 Pop tag 10.80.34.2/32 0 Po1 10.82.0.22
17 Pop tag 10.80.0.35/32 131148199 Po1 10.82.0.22
22 Pop tag 10.80.0.8/32 186 Gi1/8 10.52.132.41
24 451 10.80.0.2/32 416 Gi1/8 10.52.132.41
25 459 10.80.0.1/32 820 Gi1/8 10.52.132.41
Hope to help
Giuseppe
04-09-2009 05:41 AM
Hello Giuseppe,
many thanks for your answer.
Gianluca
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: