Easy serial interface question!

Answered Question
Apr 9th, 2009
User Badges:

Hi All


whats up gold picked up my serial inteface on my internet router as being 1.54mbs.


this is not the case, its only 1mb so the graphs are inacurate.


when I do a sh int it says bw is 1.54mbs.


my question is where is that being picked up from?


#sh int serial 0

Serial0 is up, line protocol is up

Hardware is PowerQUICC Serial

Internet address is 1.2.3.4/30

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,

reliability 255/255, txload 19/255, rxload 119/255

Encapsulation HDLC, loopback not set

Keepalive set (10 sec)

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 180389

Queueing strategy: fifo

Output queue :0/40 (size/max)

5 minute input rate 724000 bits/sec, 92 packets/sec

5 minute output rate 118000 bits/sec, 64 packets/sec

76684388 packets input, 2897637249 bytes, 0 no buffer

Received 173948 broadcasts, 0 runts, 2 giants, 0 throttles

307 input errors, 63 CRC, 242 frame, 0 overrun, 0 ignored, 2 abort

79636170 packets output, 3021991121 bytes, 0 underruns

0 output errors, 0 collisions, 1 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

DCD=up DSR=up DTR=up RTS=up CTS=up


Correct Answer by Edison Ortiz about 8 years 2 months ago

Default value assigned to T1 serial interfaces. T1 bandwidth = 1.544Mbps


If you want to change it, you can use the bandwidth command under the interface.


HTH,


__


Edison.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Edison Ortiz Thu, 04/09/2009 - 07:04
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Default value assigned to T1 serial interfaces. T1 bandwidth = 1.544Mbps


If you want to change it, you can use the bandwidth command under the interface.


HTH,


__


Edison.

Actions

This Discussion