cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
376
Views
0
Helpful
3
Replies

3745 VWIC2 Configuration help

justin.allen
Level 1
Level 1

I cant figure this out to save my life. Can somebod take a peek at this and tell me if this is right. I cant get the controllers to come up/up they are always up/down. I put them on a 2821 and they come right up. I do show them up/down but they never come up. I use the same config on the 2821, with differnt interface names of course, and it goes to up/up. Any help would be much appreciated.

card type t1 0 0

card type t1 0 1

no network-clock-participate wic 0

no network-clock-participate wic 1

no network-clock-participate wic 2

!

controller T1 0/0

framing esf

linecode b8zs

channel-group 0 timeslots 1-24

!

controller T1 0/1

framing esf

clock source internal

linecode b8zs

channel-group 0 timeslots 1-24

!

controller T1 0/2

framing esf

clock source internal

linecode b8zs

channel-group 0 timeslots 1-24

!

controller T1 0/3

framing esf

clock source internal

linecode b8zs

channel-group 0 timeslots 1-24

!

controller T1 0/4

framing esf

clock source internal

linecode b8zs

channel-group 0 timeslots 1-24

!

interface Serial0/0:0

no ip address

encapsulation ppp

no fair-queue

ppp chap hostname www

ppp multilink

ppp multilink group 1

!

interface Serial0/1:0

no ip address

encapsulation ppp

no fair-queue

ppp chap hostname www

ppp multilink

ppp multilink group 1

!

interface Serial0/2:0

no ip address

encapsulation ppp

no fair-queue

ppp chap hostname www

ppp multilink

ppp multilink group 1

!

interface Serial0/3:0

bandwidth 1536

no ip address

encapsulation ppp

no fair-queue

ppp chap hostname www

ppp multilink

ppp multilink group 1

!

interface Multilink1

ip address x.x.x.x x.x.x.x

ip wccp 62 redirect in

ip nbar protocol-discovery

ip route-cache flow

load-interval 30

ppp chap hostname www

ppp multilink

ppp multilink links minimum 1

ppp multilink group 1

ppp multilink fragment disable

service-policy output QoS-Policy-Trust

Serial0/0:0 unassigned YES manual up down

Serial0/1:0 unassigned YES manual up down

Serial0/2:0 unassigned YES manual up down

Serial0/3:0 unassigned YES manual up down

Serial0/4:0 unassigned YES manual down down

Version c3745-spservicesk9-mz.124-9.T6.bin

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

Controllers are can be only up or down.

Usually down means circuit failure.

Check their state with "show controllers T1".

Unrelated: you want network-clock-participate and -select to avoid slip errors.

So why would they come up on the 2821 and not the 3745 with the same config?

Send "show controllers T1" as taken from both routers and start reasoning from there.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card