Hello,
I've a cisco PIX515 6.3(5) with some kind of image problem.
I've issued "no access-list" in config t and it stopped responding.
It generates output below end reboots over and over.
I have tried to upload pix635.bin image file to it but this does not help.
Rebooting....
Cisco Secure PIX Firewall BIOS (4.0) #0: Thu Mar 2 22:59:20 PST 2000
Platform PIX-515
Flash=i28F640J5 @ 0x300
Use BREAK or ESC to interrupt flash boot.
Use SPACE to begin flash boot immediately.
Reading 1974784 bytes of image from flash.
################################################################################
#################################
imgsum_config: sumval(0xbd0d) md5(0x525ac23a 0x029b65fa 0x9b9c1ed3 0x6f7c4cad)
imgsum_verify: chksum(0x0 ) md5(0x7f56e8f3 0xca37f02b 0x55bcbd84 0xaf2f8ced)
Checksum verification on uncompressed PIX image failed.
Then over and over again...
Below output after binary image upload:
Serial Number: 405332336 (0x1828e170)
Activation Key: xxxx....
Do you want to enter a new activation key? [n]
Writing 1978424 bytes image into flash...
################################################################################
#################################
imgsum_config: sumval(0xbd0d) md5(0x525ac23a 0x029b65fa 0x9b9c1ed3 0x6f7c4cad)
imgsum_verify: chksum(0x0 ) md5(0x2f25a257 0xe0eae279 0xe7ade970 0xe77d71a6)
Checksum verification on uncompressed PIX image failed.
Rebooting....
Cisco Secure PIX Firewall BIOS (4.0) #0: Thu Mar 2 22:59:20 PST 2000
Platform PIX-515
Flash=i28F640J5 @ 0x300
Any input highly appreciated!
Thanks
MR