I have a new 2851 running IOS 12.4(22)YB1. It has a VIC3-2FXS/DID card in slot 0/0 and a VWIC2-1MFT-T1/E1 in slot 0/3. in the running config, I can see the config for the voice-ports, but nothing for the controller. When I run 'show controllers' I get the two GBit interfaces and the NME-CUE module in slot 1/0, but no T1/E1 card.
However, when I run 'show inventory' and 'show diag' I can see the entry for the controller.
Is there something that I'm missing here that will allow me to configure the E1 controller?