04-12-2009 07:08 AM - edited 03-15-2019 05:25 PM
Can I configure CMM module on core switch (6 E1 sub module as MGCP and H323 gateway)in the same time to register on call manager 4.2
04-12-2009 08:19 AM
yes you can, exactly the same as you would do it on any ISR
i had my 6T1 module with 2 MGCP, 2 H323 and 2 unused in my lab
HTH
java
if this helps, please rate
04-15-2009 11:52 AM
thank you so much , now I have 2 CMM modules on different core switches and I configured controller E1/4 as h323 gateway on each module , I configured route pattern on call manager ,when I point the route pattern to one h323 gateway the call established between IP phone and PBX ,
when I point the route pattern to route list contain on the two h323 gateway the call is always busy and not established
04-15-2009 12:59 PM
Hi hadelmahmoud,
CallManager will not redirect the call to GW2 in case E1 of GW1 cannot route the call to PBX.
To do this, please configure in GW1 a VoIP dial peer to reach PBX numbers with a high preference value (so that it is less preferred) and a session target pointing towards GW2. Then in GW1 configure:
voice service voip
allow-connections h323 to h323
Hope this may help you.
Best regards,
- Adrián.
05-01-2009 11:42 AM
Dear adrsaagom ,
thank you so much for your helping,
my problem is solved but could you please explain how this configuration work.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide