I have recently purchased a Cisco 871W which works wonderfully better than my old Linksys which recently passed to dead electronics heaven.
So I just discovered that I cannot open remote VPN sessions to other (outside) endpoints. This would be a VPN session established from my PC (Cisco VPN Client 4.9) through the 871W to an outside endpoint. Actually I can open a session and login but no traffic will pass.
I'm sure this is coming down to a NAT issue or a zone security policy issue.
I setup the 871 using SDM and the Firewall wizard using the Low Security option. Nothing jazzy going on here. My network is 192.168.1.0/24 and I'm Bridging the WLAN.
So here's the question... What do I need to do the allow VPN traffic to pass through the router? I would prefer to leave the zone security in place and learn it, but I have many clients that I VPN into for service.
Many thanks for suggestions.