04-12-2009 11:32 PM - edited 03-15-2019 05:26 PM
Hi, dear gurus!
How can i perform a http request in TCL? is it possibble? In my case I cannot use vxml dialog and cisco-data tag, because this request must be performed after ev_disconnect recieved, and no call leg exists to proceed the dialog (leg vxmldialog $leg_id).
Platform is 2811, IOS: c2800nm-advipservicesk9-mz.124-11.XW10.bin
If it is possible, pls give me the command syntax..
Solved! Go to Solution.
04-12-2009 11:50 PM
The commands are explained in the tcl/ivr manual that you should have already.
For an example see:
04-12-2009 11:50 PM
The commands are explained in the tcl/ivr manual that you should have already.
For an example see:
04-13-2009 12:01 AM
thanks, Paolo!
i'v read about http commands on cisco.com, but there were no examples ans syntax.
04-13-2009 12:06 AM
Thanks for the nice rating and good luck!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide