Solved: Tcl IVR --- http request (get method)

Borkes1985 · ‎04-12-2009

Hi, dear gurus!

How can i perform a http request in TCL? is it possibble? In my case I cannot use vxml dialog and cisco-data tag, because this request must be performed after ev_disconnect recieved, and no call leg exists to proceed the dialog (leg vxmldialog $leg_id).

Platform is 2811, IOS: c2800nm-advipservicesk9-mz.124-11.XW10.bin

If it is possible, pls give me the command syntax..

paolo bevilacqua · ‎04-12-2009

The commands are explained in the tcl/ivr manual that you should have already.

For an example see:

http://pbevila.fastmail.fm/public/number2name-http.tcl

View solution in original post

paolo bevilacqua · ‎04-12-2009

The commands are explained in the tcl/ivr manual that you should have already.

For an example see:

http://pbevila.fastmail.fm/public/number2name-http.tcl

Borkes1985 · ‎04-13-2009

thanks, Paolo!

i'v read about http commands on cisco.com, but there were no examples ans syntax.

paolo bevilacqua · ‎04-13-2009

Thanks for the nice rating and good luck!