04-13-2009 06:37 AM - edited 03-15-2019 05:26 PM
I cant find any information about this gateway for CUCM MGCP in 7.x. It's supported to configure, but Im not sure if I need to upgrade the IOS level of the device. It's currently working in 4.x with MGCP. Im assuming it will still work, but want to confirm. In the design guide, it has IOS levels for all other gateways, but not this little bugger.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/gateways.html
I have the option of retiring the gateway now, and replacing it will a 2800 or upgrade to 7.x, then replace it later. My DMA ran fine with the vg200 on 7x.
04-13-2009 06:55 AM
here u go Tommer
Cisco Unified Communications System Release Summary Matrix for IP Telephony for Enterprise and Midmarket
HTH
java
if this helps, please rate
04-13-2009 07:02 AM
I cant quite see the VG200 anywhere on this sheet. The IOS on the download page only goes to 12.3.26.
Am I missing something?
04-14-2009 05:51 PM
If this is a new installation it's advisable to go to the IAD or a VG224 platform rather than the VG200. The VG200 is end of support, and is for all purposes, dead.
If you would still like to run with it, you would want to upgrade the flash and run the last image that was produced for it, and hope for the best.
hth,
nick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: