Solved: TFTP Interface

Sebastian Helmer · ‎04-14-2009

Dear all,

is it possible to "say" a multilayer swtich (3750) which interface he should use for a tftp upload? With ping and trace I can, but is it for tftp for example also possible?

It would be helpfull for our firewall configuration on remote locations.

Thanks in advance

Sebastian

Giuseppe Larosa · ‎04-14-2009

Hello Sebastian,

the interface on the path to destination is chosen normally.

to have a consistent behaviour you should use something like

ip tftp source-interface vlan10

in global config

Hope to help

Giuseppe

View solution in original post

dario.didio · ‎04-14-2009

Hi,

yes you can specify this by using following command using lo0:

ip tftp source-interface Loopback0

HTH,

Dario

View solution in original post

Giuseppe Larosa · ‎04-14-2009

Hello Sebastian,

the interface on the path to destination is chosen normally.

to have a consistent behaviour you should use something like

ip tftp source-interface vlan10

in global config

Hope to help

Giuseppe

dario.didio · ‎04-14-2009

Hi,

yes you can specify this by using following command using lo0:

ip tftp source-interface Loopback0

HTH,

Dario

Sebastian Helmer · ‎04-14-2009

Hey Guiseppe, Dario,

Thanks a lot for the fast replies, very easy and I didn't find it in the conf guide...

Best regards,

Sebastian

dario.didio · ‎04-14-2009

Hi,

you can find it here:

http://www.cisco.com/en/US/docs/ios/12_0/configfun/command/reference/frgenral.html#wp1018371

HTH,

Dario

Sebastian Helmer · ‎04-14-2009

Great Dario....Thank's..