Solved: ACS 4.2, installing UDV

james.radford · ‎04-14-2009

I am trying to install a user defined vendor data file using csutil. I can successfully install the UDV using csutil, but when I look in 'interface configuration' in ACS the new UDV is not showing. The command I am running is: 'csutil -addudv 7 symbol.ini' and it tells me it has installed successfully. I am running ACS version 4.2, here is my VSA file:

[User Defined Vendor]

Name=SYMBOL

IETF Code=388

VSA 1=SYMBOL-AUTH

[SYMBOL-AUTH]

Type=integer

Profile=out

Enums=SYMBOL-AUTH-Enums

[SYMBOL-AUTH-Enums]

1=Monitor Role

2=Helpdesk Role

4=Nwadmin Role

8=Sysadmin Role

16=WebAdmin Role

32768=Superuser Role

Can anyone shed any light on this?

Jagdeep Gambhir · ‎04-14-2009

Did you try reloading the ACS? Also first you need to add any device in network configuration using that VSA.

Now it should show up in Interface configuration.

Regards,

~JG

Do rate helpful posts

View solution in original post

Jagdeep Gambhir · ‎04-14-2009

Did you try reloading the ACS? Also first you need to add any device in network configuration using that VSA.

Now it should show up in Interface configuration.

Regards,

~JG

Do rate helpful posts

james.radford · ‎04-14-2009

Brilliant I can now see the VSA. I had to specifiy a device to use that VSA in network configuration before it became visible.

Many thanks for the rapid response.

Jagdeep Gambhir · ‎04-14-2009

Please mark this post resolved so others can be benefit.

Regards,

~JG