04-14-2009 01:34 PM - edited 03-13-2019 06:15 PM
We are running ccm 5.1.3 and have an MGCP CAS T1 connected to another phone system. I would like to know if there is a way to present a predefined name on inbound calls from that T1 tie trunk. Currently we get unknown name when receiving a call. I know caller ID doesn't work but can I define a trunk group name to display so at least our users know what location is calling. We don't need the number at this point.
04-14-2009 05:49 PM
On the voice port you should be able to configure:
voice-port 0/0/0:0
station-id [name] | [number]
-nick
04-15-2009 10:55 AM
Thanks for the reply but it did not work for me. I don't see the station ID name or number when receiving a call. Does something need to be enable or disable to allow me to see it?
04-15-2009 11:39 AM
Sorry, for MGCP you would need to do this in CUCM.
It looks like in the Port configuration of the T1 you can specify a Caller ID DN. I would try putting the ID there, resetting the gateway, and seeing if this helps.
hth,
nick
04-15-2009 11:46 AM
Sorry, didn't work. I just put in a 5 digit number for the DN and it didn't come up. I did reset the gateway as suggested. Thank you.
04-15-2009 01:52 PM
It sounds like you won't be able to do this on T1 CAS. If you had a fgd-eana circuit you can receive ANI on that, however.
hth,
nick
04-15-2009 11:32 AM
Thanks for the reply but it did not work for me. I don't see the station ID name or number when receiving a call. Does something need to be enable or disable to allow me to see it?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: