04-15-2009 04:04 AM - edited 03-04-2019 04:22 AM
Hi All,
I have cisco cisco 3550 catalyst switch where rate-limit commands is not recognized.So I need to rate-limit to certain port for 11Mbps bandwidth.I tried but couldn't so ,If anyone has some idea??
Currelty client is hitting 13mbps where it should be only 11mbps..
04-15-2009 09:34 AM
Hi,
You need to use the police command instead:
http://www.cisco.com/en/US/products/hw/switches/ps646/products_tech_note09186a00800feff5.shtml
HTH
Laurent.
04-15-2009 08:16 PM
HI,
I already tried police command for restricting but could not for 11mbps link.
class-map match-any websurfer-out
match ip dscp default
class-map match-any websurfer-in
match access-group 101
!
!
policy-map 11mb-websurfer-in
class websurfer-in
police 11000000 512750 exceed-action drop
policy-map 11mb-websurfer-out
class websurfer-out
police 11000000 512750 exceed-action drop
this is what I have configured.
Its not working,
Plz help me out
04-16-2009 11:30 AM
Hi,
Did you check your classification is working correctly ?
How is the trust state of your ingress interface. If they are in untrusted mode, you need to match DSCP 0 instead of default.
Here is an example:
mls qos
!
class-map match-all data1
match access-group 145
class-map match-all data2
match ip dscp 0
!
!
policy-map EGRESS
class data2
police 11000000 512750 exceed-action drop
policy-map INGRESS
class data1
police 11000000 512750 exceed-action drop
!
!
interface FastEthernet0/x
(...)
service-policy input INGRESS
service-policy output EGRESS
!
access-list 145 permit ip any any
HTH
Laurent.
04-16-2009 08:20 PM
Hi,
Is it necessary to match ip dscp 0?? what will this command do ? and what meas trust state or untrusted state?
Thanx in advance.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: