Voice Controller-7200 router

Unanswered Question
Apr 15th, 2009

Hi,

we have a cisco router 7206VXR (NPE225) processor with VXC-2TE1+ Port adapter, 2 ports installed for

voice calls.

I can see the following configuration in the router. where is the DSP module inserted? is it inbuilt

with VXC-2TE1+ Port adapter or separately we need to install in the simm module in the router?

I can see only one DSPfarm1/0. why DSPfarm 1/1 is not showing ?

Suppose i replace the existing VXC-2TE1+ Port adapter should i change DSP configs as well?

dspint DSPfarm1/0

codec high ecan-extended

shut 0,6

controller E1 1/0

pri-group timeslots 1-16

!

controller E1 1/1

pri-group timeslots 1-31

interface Serial1/0:15

no ip address

encapsulation hdlc

no logging event link-status

isdn switch-type primary-qsig

isdn protocol-emulate network

isdn incoming-voice voice

isdn T310 40000

isdn contiguous-bchan

no cdp enable

!

interface Serial1/1:15

no ip address

encapsulation hdlc

isdn switch-type primary-qsig

isdn protocol-emulate network

isdn incoming-voice voice

isdn T310 60000

no cdp enable

!

voice-port 1/0:15

input gain 6

output attenuation -1

echo-cancel coverage 32

!

voice-port 1/1:15

input gain 7

output attenuation 3

echo-cancel coverage 24

echo-cancel mode 2

music-threshold -50

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Shibu1978 Thu, 04/16/2009 - 00:01

Dear Sushil,

Thanks for the reply.

Please someone provide some more info regarding this.

Thanks

Actions

This Discussion