cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
548
Views
0
Helpful
5
Replies

Replication not working just for AAA clients in NDG

jcarvalh
Level 1
Level 1

Hello.

I have configured replication between two ACSv4.2.

Everything worked fine except the AAA clients belonging to NDGs.

I am allowing tcp/2000 in FWSM an I am not using NAT.

The rest of the configs seem to be OK since I was able to replicate all the rest.

Does anyone have any ideia about this problem?

Thanks in advance,

Joao Carvalho

5 Replies 5

Jagdeep Gambhir
Level 10
Level 10

Please go to ACS--->Interface configuration--->Advanced option--->Enable NDG -->Submit.

Check now ...NDG's should be there.

Regards,

~JG

Do rate helpful posts

Hello.

NDG were already active.

NDG from primary ACS apear on secondary, however their content do not (AAA clients).

Joao Carvalho

Do verify the required replication components are selected on primary ACS such as User Database and Configurations etc.,check boxes are selected in send option and the same components are selected for receive option check box in secondary ACS.

Hope this helps

Ahmed

Hello.

That was also done. It looks like a mirror :)

Thanks,

Joao

P.S. - I am going to install ACS again, don't see any other problem.

Moreover Network Configuration device table can be backed up from the running ACS and can be restored on another ACS with missing NDG's under Backup and Restore.

Configuration of replication between ACS's will be followed.

HTH

Ahmed

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: