Convert 1131 to LWAPP using conversion tool

tverhoeven · ‎04-15-2009

recently I used the conversion tool to convert 5 AP's to LWAP. 3 were in one building/subnet and 2 were in 2 different buildings/subnets. The conversion tool said everything worked but when the ap's rebooted only one out of 5 actually connected to the controller. I had to go touch the other 4 and tell them the ip of the controller.

the one that came up was part of the 3 that lived in the same subnet.

I have DHCP setup across all scopes with option 43 and one of the controllers set as a master.

any thoughts???

thanks

Robert.N.Barrett_2 · ‎04-15-2009

It's probably too late now, but it would have been helpful to see the console logs from the AP's that failed to join the controller.

tverhoeven · ‎04-15-2009

it happened monday morning and I fixed the last one yesterday morning.

Leo Laohoo · ‎04-15-2009

Before you converted your AP's to LWAP, did you endable DNS and/or DHCP (Option 43 and/or Option 60)?

tverhoeven · ‎04-16-2009

Option 43 in DHCP has been setup across all scopes.