04-15-2009 07:18 AM - edited 03-04-2019 04:22 AM
I have a current T-1 running on a WIC-1DSU-T1-V2. I am planning on getting a second T from the carrier for a mutlilink connection. Any problem mixing the current card with a HWIC-1DSU-T1 ?
I noticed the WIC is going EOL
Solved! Go to Solution.
04-15-2009 07:30 AM
BRIAN,
Q. How are these HWICs different from WIC-1DSU-T1-V2, WIC-1T, WIC-2T, and WIC-2A/S?
A. The new HWICs have the same software features as the older WICs. The HWIC-1T has a Cisco Smart Serial connector where the WIC-1T had a DB-60 connector. The front-end NEBS protection of HWIC-1DSU-T1 has also been improved.
Please check out this link.
http://www.cisco.com/en/US/prod/collateral/modules/ps5949/qa_c67-490366.html
You should be fine as long as Box can recognize both interfaces. Then go configure multilink functions.
HTH,
Toshi
04-15-2009 07:27 AM
No, there should not be a problem.
04-15-2009 07:30 AM
BRIAN,
Q. How are these HWICs different from WIC-1DSU-T1-V2, WIC-1T, WIC-2T, and WIC-2A/S?
A. The new HWICs have the same software features as the older WICs. The HWIC-1T has a Cisco Smart Serial connector where the WIC-1T had a DB-60 connector. The front-end NEBS protection of HWIC-1DSU-T1 has also been improved.
Please check out this link.
http://www.cisco.com/en/US/prod/collateral/modules/ps5949/qa_c67-490366.html
You should be fine as long as Box can recognize both interfaces. Then go configure multilink functions.
HTH,
Toshi
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide