Get CME to add digits to internal calls

Unanswered Question
Apr 15th, 2009

If I have two CME sites, both with 4 digits extensions, one site is 4XXX and another 5XXX. I'm trying to get it so at site 4, they can just dial the 3 digits for onsite calls and the CME will add the 4 to the 3 digit number, and so on at site 5. I have the translation rule setup properly, I'm just not sure where to put it when the call is not going to a trunk or pots line. Any ideas?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)


This Discussion