04-15-2009 11:26 PM - edited 03-06-2019 05:12 AM
Hii Guys,
I have to configure Ether-Channel between two links with different banwidth capacity i.e 10 Mb and 18 Mb.
Guess it should work,but have bit confusion that what would happen if low bandwidth link i.e 10 Mb will utilised peak. Is there may be errors or isolation.
Second, If i make etherchannel with three links with capacity 10 Mb , 10 Mb and 8 Mb then what would be the result.
PLease share if anyone have some good documents on the same.
04-16-2009 12:00 AM
All elements of a port channel must be the same speed - I don't know how you would get an 18Meg ethernet connection anyway?
See document ref 12023
http://www.cisco.com/en/US/tech/tk389/tk213/technologies_tech_note09186a0080094714.shtml
04-16-2009 04:09 AM
What you are saying cannot be done as previously posted all links must be equal , 100 meg , gig etc...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide