Add devices manually

Unanswered Question
Apr 16th, 2009

I'm new on version 3.1, and I don't understand how does it work.

I want to add nodes only manually, I don't want to use Seed Devices. I add them from CS>Device Management, they say me nodes had been added properly, but they appear always as Unreachable. Ping and snmpwalk returns OK.

Should I configure something on Device Discovery?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mserranocisco Thu, 04/16/2009 - 05:48

Yes, I supose...

I have defined Default Credentials and checked Use Default Credentials when adding devices.

Devices added appear properly on CM, but not anywhere else.

I have added them from CS>Device Management, but list is empty, if I try to add a node again, it says it exists... I don't understand anything :-(


This Discussion