cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1137
Views
0
Helpful
5
Replies

ACS cannot remove AAA server

srosenthal
Level 4
Level 4

I have an ACSSE that for some reason has two instances of itself listed under AAA servers. The first one says "self" and shows a 127.0.0.1 address. The second one shows it's real address. I am trying to remove the second one but there is no option to delete.

I think this is causing my database replication to fail. My primary ACSSE is listed under the AAA servers screen. This machine that has two self's listed is not allowing the database replication saying invalid secret key. I did verify the keys are the same.

Seth

1 Accepted Solution

Accepted Solutions

You should be able to remove one of the Servers, even if it is the one with the correct IP, then try:

In order to resolve the 127.0.0.1 self problem, you can backup and restore the .DMP files on a fresh installation of ACS for Windows 4.2 and modify the 127.0.0.1 entry with the desired IP address.

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_tech_note09186a00808d9199.shtml#res

ACS v4.2.0.124 90-Days Evaluation Software

http://www.cisco.com/cgi-bin/tablebuild.pl/acs-win-eval

Once you restore the fixed database, please confirm your Proxy Distribution Table Entries.

The ACS Server should be in the Forward To box.

View solution in original post

5 Replies 5

Jagdeep Gambhir
Level 10
Level 10

I would suggest to open a TAC case to get it fixed.

Regards,

~JG

When looking at the AAA servers, should I see the local unit assigned as "self" with it's actual address, or with a 127.0.0.1 address?

When I first setup both of the ACS servers, they both had "self" listed with the 127.0.0.1 address. However, after running the recovery cd and re-installing both units, the "self" now only shows up with the actual IP address.

Thanx, Seth

You should be able to remove one of the Servers, even if it is the one with the correct IP, then try:

In order to resolve the 127.0.0.1 self problem, you can backup and restore the .DMP files on a fresh installation of ACS for Windows 4.2 and modify the 127.0.0.1 entry with the desired IP address.

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_tech_note09186a00808d9199.shtml#res

ACS v4.2.0.124 90-Days Evaluation Software

http://www.cisco.com/cgi-bin/tablebuild.pl/acs-win-eval

Once you restore the fixed database, please confirm your Proxy Distribution Table Entries.

The ACS Server should be in the Forward To box.

I have the same issue. did you ever get this issue resolved?

Thanks

I can't even remember the problem as it has been 6 years.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: