04-16-2009 10:57 AM
I have multiple servers attached to this switch-A.but not discover by UT not all but some of them. when I run sh mac-address-table on the switch I have found the missing server mac-address, also when I have run sh ip-arp to the mls switch which is the switch-A attached too. I have seen the correct mac-to-ip address translation for all servers not discovered by UT.
I don't know related to this but when I run snmpwalk from device center from this switch-A for "ifDesc. and did not show all the interface.this switch has 9 blades but ifDesc show only for the first 3 blades?not sure UT and snmp related too. just to give background. or any switch configuration issue.
Thanks
04-16-2009 11:01 AM
Post the show int status and show mac-address-table output. What is one MAC that is missing?
04-16-2009 11:39 AM
I have attached show int stat for blade 8 which i have undiscovered the servers on the following ports not discovered by UT.
I have also include which ports has undiscovered servers.regarding mac-table. there is no missing mac address, instead I said all the mac-addresses for missing servers discovered on this switch.again all mac-addressed discovered, also the ip -address discover on the MLS switch. the mystery is why with all this information not discovered by ut?
04-16-2009 11:45 AM
It looks like the ports with missing end hosts are trunk ports. UT 4.0 does not acquire end hosts on trunk ports. Support for this was added in Campus Manager 5.0.
04-16-2009 12:06 PM
Thanks a lot J. I was suspicious on that!the good news is will have Campus Manager 5.0 very soon.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide