04-16-2009 02:30 PM - edited 03-04-2019 04:24 AM
I get this msg
duplex mismatch discovered on GigabitEthernet0/0 (not half duplex) with Switch FastEthernet1/0/46 (half duplex).
when I look @ the config , I see both side full
Thanks
R1 #show run int g0/0
interface GigabitEthernet0/0
description gi0/0-chpk-sw1-fa1/0/46
ip address x.x.x.x x.x.x.x
no ip redirects
ip ospf cost 50
duplex full
speed 100
media-type rj45
no standby redirect unknown
standby 1 ip x.x.x.x
standby 1 preempt
standby 1 track Serial0/0/0
end
sw1 #show run int fa1/0/46
interface FastEthernet1/0/46
description fa0/46-R1-G0/0
switchport mode dynamic desirable
speed 100
duplex full
spanning-tree portfast
end
04-16-2009 04:21 PM
Try leaving the speed as 100 but duplex as auto
04-17-2009 07:56 AM
auto on both sides ?
04-17-2009 08:26 AM
Bounce both the ports. If that does not work set both to half then back to full again.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide