cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1764
Views
3
Helpful
5
Replies

etherchannel configuration between cisco and nortel

ciscorajeev
Level 1
Level 1

hi,

i am trying to configure etherchannel between cisco 6509 and nortel 8600 switch. but soon after configuring the port channel interfaces are going in error disable state. could anyone send the configuration for creating L2 etherchannel between cisco and nortel switches.

Thanks & Regards

Rajeev

1 Accepted Solution

Accepted Solutions

echelon360
Level 1
Level 1

hello rajeev,

Nortel uses MLT for etherchannel configs.

have a look at page 329 of the attached doc.

HTH

View solution in original post

5 Replies 5

echelon360
Level 1
Level 1

hello rajeev,

Nortel uses MLT for etherchannel configs.

have a look at page 329 of the attached doc.

HTH

Thanks...

Rajeev

ciscorajeev
Level 1
Level 1

Description: Multicast problem:

Topology :Remote site->MPLS cloud->switch1 3750->ASA 5510-> LAN switch 3560E

Switch1 inside interface(int vlan) which is connected to ASA is configured with IP PIM passive.

Q: Will my multicast work on LAN and able to receive multicast traffic from remote site?

you'll need multicast VPN inside the MPLS cloud. Ask your ISP if they have it - they should.

Thanks for your comment...

yes they have VPN in cloud, customer says some time multicast work sometime doesn't. Tac has suggested to upgarade the image of LAN switch as the existing image only support IP PIM PASSIVE command on edge switch. But customer says why it works somtime and othertime stops working...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco