04-17-2009 05:50 AM
suppose i connected one ip phone to the switch and one machin to that ip phone. i know only the MAC Address of the IP phone and i want to know the IP address of the system which is connected to the IP phone with the help of command on switch.... is thr any command on switch
04-17-2009 06:18 AM
Hi awdhoot_t,
In the switch, use the command:
Switch# sh mac-address-table interface
where
Then you can use sh arp.
Hope this helps you, if so please rate.
Best regards,
- Adrián.
04-17-2009 02:18 PM
show mac- | i aaaa.aaaa.aaaa
Use mac address in lower case form.
Then if your output is similar to this:
232 000d.290b.e3af DYNAMIC Fa0/21
Do a 'show mac- | i Fa0/21'
This will tell you the other MAC on the port. Sh arp will not because it's a layer 3 command.
-nick
04-17-2009 04:20 PM
Hello Nick,
But, he wants to know IP address of the machine attached to IP Phone...
Best regards,
- Adrián.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: