Disable 5Ghz Radio module in LAP1252AG

Unanswered Question
Apr 19th, 2009
User Badges:

Hello,


I have a LAP1252AG-E-K9 managed by a WLC embedded in a Catalyst3750G. My question is the following: how can I disable the 5GHz radio module using the WLC (I desire leave only the 2.4GHz module). In addition : in case I put in the LAP only 3 2.4Ghz antennas the 5GHz module is automatically disable?

Thank you, Marco

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Sun, 04/19/2009 - 16:17
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Physically remove the 5Ghz radio module.


Are you trying to disable 802.11a? If you are, go to Wireless 802.11a/n and under Network, un-tick 802.11a Network Status. Do the same to 802.11b/g/n.


Hope this is what you are looking for.

Robert.N.Barrett_2 Mon, 04/20/2009 - 10:01
User Badges:
  • Bronze, 100 points or more

You should be able to go to the Wirless -> AP's -> Radios -> 802.11a/n AP's and choose to configure the AP. Once you are on the config screen, you can administratively disable the 802.11a/n radio on the 1250.

gamccall Mon, 04/20/2009 - 10:13
User Badges:
  • Silver, 250 points or more

I haven't tested this but I beleive I've read that just disabling the radio via controller doesn't actually solve power problems- if you're trying to get full power to one 2.4 radio using just 15.4 watts, I believe you do have to physically uninstall the other radio.


If anyone can confirm otherwise, please post.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode