Any one Can help me to configure ASA active standby configuration, here I want to use mgt interface for both failover and state full failover link, why because all of my other interfaces are been used for
Production (internal, external, dmz, wan), that leaves me the mgmt port to for the failover. My âprimaryâ ASA is fully configured and up and running. My "secondary" ASA has just been taken out of the box
What do I need to do on the out of box "secondary" firewall, to prepare it, so the primary can talk to secondary , do I use console for initial configuration on secondary ASA
ip address 192.168.100.1 255.255.255.0
how do I change management interface to normal interface for failover?
no ip address
please correct above syntax
failover lan unit secondary
failover lan interface failover management0/0
failover lan enable
failover key cisco
failover interface ip failover 22.214.171.124 255.255.255.0 standby 126.96.36.199
Failover interface ip state ? 255.255.255.0 standby ?