CISCO 1242 + WLC4402

Answered Question
Leo Laohoo Tue, 04/21/2009 - 13:53
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Hi Alexandrine,


Here's the gist of it all. By default, if you configure your WLC normally, the AP's run in a mode called "AP Mode". When this happens, if your one-and-only goes down for maintenance (like firmware upgrades), the AP's will stop and search for a controller until one is found.


However, if you operate in H-REAP mode, when your one-and-only WLC goes down AND your don't reboot your AP's, the AP's will operate normally.


Does this answer your question?

Correct Answer
Leo Laohoo Tue, 04/21/2009 - 15:58
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Leo Laohoo Wed, 04/22/2009 - 14:45
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Thanks for the ratings. :)

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode