04-21-2009 05:26 PM - edited 03-04-2019 04:27 AM
Hi, I have to allow tcp 45.194.169.115 , 61.202.173.243, 14.234.41.250 to any eq 443. But I have use ACL in Single line only. Please help what should be ACL...
04-21-2009 07:51 PM
Rupesh,
I can't do that in a single line. I can do with a single ACL configured with 3 ACEs.
!
ip access-l ex TEST
permit tcp host 45.194.169.115 any eq 443
permit tcp host 61.202.173.243 any eq 443
permit tcp host 14.234.41.250 any eq 443
!
HTH,
Toshi
04-22-2009 02:31 AM
This cannot be accomplished in one line. As noted above, you must use 3 lines if you only want to allow the specified hosts.
04-22-2009 02:34 PM
As what the others have posted, you can't put different hosts in ONE ACL statement.
You can, on the other hand, put in one statement a group of ports in an extended access list.
04-23-2009 07:08 PM
Hi, I heard this may be like--
14.194.41.114 20.40.132.137 (E.g Network ID and Wild Card). Any idea?//
01-23-2011 03:59 AM
I believe it is
permit tcp 12.194.41.114 49.40.132.137 any eq 443
& permit tcp 12.194.41.114 206.215.123.118 any eq 443 on an ASA
Very intresting question, have to go down to binary level to do this
01-24-2011 07:29 AM
Hi
You can do it in one line as jennyjohn has wrote it.
But I think jennyjohn missed one bit, it should be
permit tcp 12.194.41.114 51.40.132.137 any eq 443 on an ios router
or
permit tcp 12.194.41.114 204.215.123.118 any eq 443 on an ASA
/Mikael
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: