cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5179
Views
0
Helpful
3
Replies

Do Switches Support IPSEC?

visitor68
Level 4
Level 4

Does any Cisco Catalyst LAN switch support IPSec and IKE?

I have a 3550...I think Im out of luck. I don't see either feature in the navigator...

Thanks

1 Accepted Solution

Accepted Solutions

Marvin Rhoads
Hall of Fame
Hall of Fame

I believe you need to step all the way up to the 6500 series to get IPSec/IKE.

See the IPSec portfolio data sheet at http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6635/ps7180/prod_brochure09186a00801f0a72_ns142_Networking_Solutions_Brochure.html

For the 6500, see the configuration note at http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800cdfc9.shtml

If you'd like to share why you ask, there may be other solution sets more attractive than using a 6500 series switch.

View solution in original post

3 Replies 3

Marvin Rhoads
Hall of Fame
Hall of Fame

I believe you need to step all the way up to the 6500 series to get IPSec/IKE.

See the IPSec portfolio data sheet at http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6635/ps7180/prod_brochure09186a00801f0a72_ns142_Networking_Solutions_Brochure.html

For the 6500, see the configuration note at http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800cdfc9.shtml

If you'd like to share why you ask, there may be other solution sets more attractive than using a 6500 series switch.

Hi there:

Thanks for the response.

Yes, I believe you're right. IPSec and IKE seem to be strictly found on routers, not switches, except for the 6500 series.

I just wanted to ask because I am in a lab and wanted to do some testing.

Thanks

h17m4n18727
Level 1
Level 1

Hi,

Can I open this up again? I have two 3560 Switches. And the carrier in between ony allows 50 MAC Addresses on their link. I got them to up this 100, but I am not sure if this will be enough. If I can create a tunnel in between then the carrier should only see the two peer IP Addresses.

We do not have budget for 6500s and the networks have to be in the same broadcast domain. I currently have VLANs trunked accross the link extending the onsite LANs to the other site.

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card