csim start

Unanswered Question
Apr 21st, 2009

Can we use csim start <Mobile nukmber> command to check the voice call connection for PRI lines.Because for few service provider the calls are not established.when checked with debug we have found an error "**ERROR**: isdnAsn1Component: ERROR" & "**ERROR**: process_facility_supp_services: Decode of facility IE operation failed"

Pls help..

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
gogasca Tue, 04/21/2009 - 23:14

yes u can try, but whats the call flow...?

Can you use an IP communicator? or hard phone?

can you post the debugs here?

partheeban1 Wed, 04/22/2009 - 01:23

Hi gogasca,

Thanks for your response.

I am not using any ip phones or communicator as of now.Just i am using csim start from router to my mobile number. Router has two pri lines from different service providers.when i dial with 1st SP the call is connecting perfectly but when i go for the second pri the call is disconnecting.I have done the same configuration for the both lines.also attached the failed call logs.




This Discussion