04-22-2009 02:26 AM - edited 03-06-2019 05:19 AM
We have a Cat4507r but when I are connected by console or telnet with a monitor console command it doesn't show us any cahnge in the status of its interfaces or any tipe of change that other serie switch show us indeed.
Solved! Go to Solution.
04-22-2009 11:44 PM
Hi,
Some Catalysts - (The 6500&7500 for example) don't by default log Interface changes.
You need to enable the logging of them using "logging event link-status default"
Hope that helps.
Nick
04-22-2009 02:29 AM
Hi There,
Try:
logging console debugging (for console cable)
logging monitor debugging (For ssh connection with "terminal monitor")
Nick
04-22-2009 04:56 AM
Thanks Nick, we already did it and it doesn't work.
04-22-2009 05:09 AM
Are you getting absolutely nothing at all, or just not the Interface statuses?
What if you do a debug ip icmp and ping the device?
If you are getting something, then it's just a matter of setting up the correct snmp traps.
Nick
04-22-2009 05:57 AM
Hi Nick,
We are using SNMP traps and logging traps notifications to get all the manager information but the same configuration is running in other serie Catalysts and they show us console information about port link changing state for exemple.
This is our logging config:
logging trap notifications
logging facility local3
logging source-interface Vlan20
and SNMP config tooâ¦
so do you think it is normal in series Catalyst 4500 if you are using snmp and logging traps?
thanks Nick
Oscar
04-22-2009 11:44 PM
Hi,
Some Catalysts - (The 6500&7500 for example) don't by default log Interface changes.
You need to enable the logging of them using "logging event link-status default"
Hope that helps.
Nick
04-23-2009 12:27 AM
As Nick says with some software releases for certain series it's disabled by default.
I confirm that with cat4500-ipbasek9-mz.122-50.SG1.bin (and probably also with software releases before) you need to enable it globally with the command
logging event link-status global
or you can enable it on an interface basis as you don't want to receive traps/loggings for user ports.
04-23-2009 05:07 AM
Hi there,
I agreed with all you. I have tried it and it is working in the cat 6500 series, not in 4500 series but I think it is coz the IOS doesn't support the command. I am going to look for the command line for my IOS version.
Thank you very much folks for your help and time.
Kind regards.
Oscar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: