Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
516
Views
0
Helpful
1
Replies

Wireless Controller 4400 Series - Peer to Peer Blocking

Jason Caron
Level 1
Level 1

‎04-22-2009 09:40 AM - edited ‎07-03-2021 05:28 PM

Software Version 3.2.195.10

Is there anyway to enable peer to peer blocking on a Wireless Controller with the above Software Version?

Looking for the equivalent of public secure packet forwarding in a Cisco 1200 AP.

Labels:
0 Helpful
1 Reply 1

gamccall
Level 4
Level 4

‎04-22-2009 10:53 AM

This setting is per WLAN in current WLC code versions, but it's global in earlier versions. To turn peer to peer blocking on globally on your controller, enter this command at the CLI:

config network peer-blocking enable

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card