04-22-2009 10:29 AM
The NM_NAM module that we have installed on our 3825 router wont accept the following session attempt:
"service-module analysis-module 1/0 session".
Here is the output:
lo-mpls3825#ser an 1/0 sess
Trying 172.31.200.1, 2066 ...
% Connection timed out; remote host not responding
lo-mpls3825#ser an 1/0 stat
Service Module is Cisco Analysis-Module1/0
Service Module supports session via TTY line 66
Service Module is in Steady state
Getting status from the Service Module, please wait..
Cisco Network Analysis Module (NM-NAM), version 3.5(1)
It seems that the module is ready. We can telnet to it from other places on the network. I need to access it from the router so I can perform a code upgrade by going into the Boot Helper option when it loads.
Any ideas why this error?
Thanks
04-22-2009 10:45 AM
Please post the show tech from this 3825.
04-22-2009 12:40 PM
04-22-2009 06:48 PM
Try this from the router:
clear line 2006
telnet 172.16.132.10 2066
04-23-2009 08:39 AM
It wont let me perform clear line 2066
see below
lo-mpls3825#clear line ?
<0-337> Line number
async-queue Clear queued rotary async lines
aux Auxiliary line
console Primary terminal line
tty Terminal controller
vty Virtual terminal
x/y Slot/Port for Modems
x/y/z Slot/Subslot/Port for Modems
It wont take anything past 337 for the line number...
04-23-2009 08:56 AM
Sorry, typo:
clear line 66
04-27-2009 07:47 AM
I also wanted to ask if you could send a link to where I could download any of the current images for the NAM for. I would like to get to version 3.6.1b as my other router is using that here.
Also a link to any of the patches that are available.. I need a crypto patch for the NM-NAM.
04-27-2009 09:56 AM
All NAM code can be downloaded from the following link:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: