04-22-2009 10:31 AM - edited 03-11-2019 08:21 AM
Hi
Problem1: I am trying to upgrade pix 515e from 6.3(1) to 8.0(4) version in monitor mode and I am not able to do that.
monitor>interface 1
address 192.168.16.250
server 192.168.16.20 (my laptop with tftp program on)
file pix804.bin
tftp
I get the below
monitor> tftp
tftp pix804.bin@192.168.16.20
TFTP failed (return:-1 arg:0x0)
Laptop to pix (no ping response)
Pix console to laptop (pin ok)
Pix console to pix interface 1 192.168.16.250 (no ping response)
I went through these forums and tried with different tftp programs (cisco tftp, 3cdaemon, pumpkin, tftpd32) and no luck.
problem2:
On show version, I see
This PIX has a Failover Only (FO) license.
Can this only be used with only active/failover config? What should I do if I want to use as a normal standalone firewall.
Please advise.
04-22-2009 11:50 AM
try below
failover active
conf t
interface e0
description firewall Interface
security-level 100
ip address 10.1.1.82 255.255.255.0
no shut
end
04-22-2009 12:26 PM
If you have no ping then you have a connectivity issue.. Try going through a switch to connect the PIX and PC, or verify the cross over cable
04-27-2009 08:49 AM
I checked both ways connecting through the switch and also with crossover. No luck. I wonder why its own interface is not pingable!
Any other opinions?
If not this how can I upgrade through the interface command. I have a hard time mentioning the right path. The file is on my desktop
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: