I installed a WS-X6348-RJ-45 into a Cisco 6506 switch on slot 3. My IOS version is s72033-pk9s-mz.122-18.SXD5.bin.
The card keep giving the following errors below.
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
3 48 48 port 10/100 mb RJ45 WS-X6348-RJ-45 SAL0704C6M9
5 2 Supervisor Engine 720 (Active) WS-SUP720-3B SAL1033Y3R8
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
3 000b.fdad.2b58 to 000b.fdad.2b87 7.0 5.4(2) 8.3(0.156)RO PwrDown
5 0016.9df6.9570 to 0016.9df6.9573 5.2 8.4(2) 12.2(18)SXD5 Ok
Mod Sub-Module Model Serial Hw Status
--- --------------------------- ------------------ ------------ ------- -------
5 Policy Feature Card 3 WS-F6K-PFC3B SAL1032XKA0 2.3 Ok
5 MSFC3 Daughterboard WS-SUP720 SAL1033Y6K7 2.5 Ok
Mod Online Diag Status
--- -------------------
3 Unknown
5 Pass
*****************************************
00:01:42: %PM_SCP-SP-6-LCP_FW_ERR_INFORM: Module 3 is experiencing the following
error: Coil Master CPU Interface Error - Coil #2
00:01:47: %PM_SCP-SP-6-LCP_FW_ERR_INFORM: Module 3 is experiencing the following
error: Coil Master CPU Interface Error - Coil #3
00:01:52: %PM_SCP-SP-6-LCP_FW_ERR_INFORM: Module 3 is experiencing the following
error: Coil Master CPU Interface Error - Coil #0
00:01:59: %DIAG-SP-3-MAJOR: Module 3: Online Diagnostics detected a Major Error.
Please use 'show diagnostic result <target>' to see test results.
00:01:59: %OIR-SP-3-LC_FAILURE: Module 3 has Major online diagnostic failure, Ca
rd will be powered down. Please check bootflash diaginfo file for detailed diagn
ostic result.
00:01:59: %C6KPWR-SP-4-DISABLED: power to module in slot 3 set off (Diagnostic F
ailure)
KAD-SW01#
