cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
419
Views
0
Helpful
4
Replies

Pix 501 Tunnel not connecting

b.schwartz
Level 1
Level 1

We switched internet service providers so i had to change the peer ip address and since than i cannot get the tunnel to connect any ideas?

4 Replies 4

andrew.prince
Level 10
Level 10

Check your config, check if the providr allows IPSEC traffic - also consider configuring NAT-T.

HTH>

Thank you for your response. As i pointed out in the original post the configuration is about a year old and was working fine. As far ipsec traffic i will check and let you know.

I spoke to the isp and they claim they are not blocking ipsec traffic

Well just in case they - enable NAT-T on the tunnels

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: